Use for new, fine, abrasive snow with temperature from -30°C to -10°C. In case of very abrasive old icy snow (spring snow and glacier snow), this paraffin can be used over the fluorocarbon waxes FP4 to increase their long lasting. The final result will be a lower hydrophobia. It can also be used as universal hardener to protect the polyethylene base along the steel edges foils in case of natural or artificial very abrasive snow. Use hot application with the waxing iron at 160°C.

Available packaging

• Cod. MW0810 - 250gr
• Cod. MW0820 - 1kg

All type of snow
snow temperature: –30°/–10°C
iron temperature: 160°C

HOT APPLICATION PROCEDURE WITH WAXING IRON

1. Rub the paraffin block on all the ski base leaving a uniform layer of product.
2. Melt the wax by spreading it forward and backward with the waxing iron at a temperature of 110°C., then carry out a final passage from the tip to the tail (nearly 5 cm. per second);
3. Wait at least 15 minutes for the ski wax to harden and the ski base to cool down;
4. Remove the was in excess with a sharpen plexy scraper doing little pressure;
5. Free the ski side and edges side from hardened paraffin with the plexy scraper;
6. Brush the ski base with a hard nylon manual brush;
7. Brush the ski base with a manual or roto hard horsehair brush;
8. Polish the ski base with a manual or roto soft nylon brush.